Controls and Features (continued)
Control Panel
1
2
3
4
5
1[TEMP] Indicator
| 6 |
STAND BY |
|
LAMP TEMP OPERATE | 7 |
| |
| 8 |
MENUEXIT
9
ENTER
p
PRESET
HIDE 
q
7[OPERATE] Indicator
Blinking : Indicates that temperature inside this unit is ab- normally high. (☞ Pages 11, 33)
Light on: When this unit is in operation (during projec- tion). (☞ Page 20)
2[LAMP] Indicator
Light on: Indicates that lamp has been used for more
than 1900 hours. (☞ Pages 11, 28)
Blinking : Indicates that lamp usage time (about 2000 hours) is exceeded. Replace the lamp. (☞ Pages 11, 28, 33)
3[MENU] Button
Press this button to display the menu. Pressing this but- ton when the menu is displayed clears the menu. (☞ Pages 23, 24)
4Cursor [5/∞/2/3] Buttons
Use these buttons when adjusting the menu items. (☞ Pages 23, 24)
5[PRESET] Button
Use this button to reset the values to factory settings when the “Gamma”, “Color temp.”, “Mask” or “Picture shift” item in the menu is selected.
6[STAND BY] Indicator
Light on: When in the standby mode. (☞ Page 11)
Blinking : When in the cool down mode. (☞ Page 11)
8[OPERATE] Button
When this unit is in the standby mode, pressing this but- ton for more than 1 second will turn this unit on and cause the [OPERATE] indicator to light up.
Press it for 1 second or more again to switch the unit to the cool down mode, which will automatically switch to the standby mode after about 90 seconds. (☞ Page 20)
●The [OPERATE] button will not work within approxi- mately 1 minute after the light source has been turned on. Start operation only after 1 minute’s time.
9[EXIT] Button
Press this button to return to the previous hierarchical menu (for example, to return from submenu to main menu). Pressing this button when the menu is displayed will clear the menu. (☞ Pages 23, 24)
p[ENTER] Button
Press this button to show the next hierarchical menu (for example, to enter submenu from main menu). It is also used when “ENTER” is displayed against a selection item on the menu screen. (☞ Pages 23, 24)
q[HIDE] Button
Use this button to temporarily clear the video image. Press again to resume. (☞ Page 21)
10
