Connector Panel, Service Terminal | Meridian Audio D-ILA 1080MF2

Connector Panel

1 2

SYNC	RS-232C	DVI
OUT SERVICE
CONTROL		VIDEO IN

	1 [SYNC OUT] Terminal	3 [RS-232C] Terminal (D-sub 9 Pin)
	This terminal is intended for servicing purposes. Do not	This is the RS-232C interface-specific terminal. This unit
	use it.	can be controlled by a computer connected externally.
	Using it may give rise to error or malfunction of the unit.	(☞ Page 18)
	2 [SERVICE] Terminal	● For details, please check with your authorized dealer.
	2 [SERVICE] Terminal	4 [DVI] Terminal (DVI-D 24 Pin)
	This terminal is intended for servicing purposes. Do not	4 [DVI] Terminal (DVI-D 24 Pin)
	use it.	This is an input terminal for video signals.
	Using it may give rise to error and malfunction of the unit.	Connect this to a dedicated digital video processor.
		(☞ Page 18)

Page 9

Image 9

Meridian Audio D-ILA 1080MF2 Connector Panel, Sync OUT Terminal RS-232C Terminal D-sub 9 Pin, Service Terminal

Contents

ILA 1080MF2 FCC Information U.S.A. only About the installation placeMachine Noise Information Germany only About burning-in of the D-ILA device Power cord Do not allow any unqualified person to install the unit Do not cut off the main plug from this equipment How To Replace The Fuse Standard for gauging replacement time of components Accessories Contents Front Side/Top Surface/Left Side Controls and Features Rear Side/Right Side/Bottom Surface Service Terminal Connector PanelSync OUT Terminal RS-232C Terminal D-sub 9 Pin DVI Terminal DVI-D 24 Pin Control Panel Indicator Display on the Control Panel Remote Control Precautions for Using Batteries Loading Batteries into the Remote ControlOpen the back cover Load the batteries Installation Environment Installing the ProjectorPrecaution for Usage Adjusting the Inclination Projector and Screen Installation Precautions for Ceiling-mountMounting this Unit Screen Size and Projection Distance Screen Installation Effective Range of Remote Control Unit When reflecting off a screen When directing remote control unit toward this unit Connecting to Devices Connecting to Various DevicesRight Side of this unit Control from external device When using this unit, remove the lens cap Connecting the Power Cord supplied Turning on the power Basic Operation ProceduresAdjusting zoom screen size Adjusting focus Pull out the power plug from the power outlet Turning off the powerHiding the image temporarily Press Hide Menu Structure Adjustments and Settings Using Menus Menu Operation Buttons Button Function This Unit Remote Control Unit Press the Menu button Press 5/ ∞ to select a main menu item and EnterTo confirm Image adjust Menu Menu ConfigurationSet up Menu Options Menu Screen Masking Press 5/∞ to select Set up, followed by pressingProject image onto the screen Press the Menu button Press 5/∞ to select Options, followed by press Ing Enter Picture Shift Setting About Lamp Replacement Replacing the LampLight-source Lamp and Lamp Usage Time Pull out the lamp unit Loosen the screws on the lamp unit and lift up the handleInsert the new lamp unit until it is fully Tighten the screws of the lamp unit Close the handle Insert plug into the power outlet Resetting Lamp TimeTo ensure the lamp time has been reset Exit Cleaning and Replacing the Filter Message Cause Details What to do when these messages are displayed Indicator About warning indicatorsPlease follow the procedures below Actions to be taken upon warning indications Troubleshooting Terminal Description Pin No Signal NamePin Arrangement RS-232C Terminal RS-232C External Control External control command table Operation mode Only Asking command is possibleSpecial parameters Specifications Front Dimensions Unit mm TopBottom Side MF2MIman v0.90ß

Connector Panel

1 [SYNC OUT] Terminal

3 [RS-232C] Terminal (D-sub 9 Pin)

2 [SERVICE] Terminal

4 [DVI] Terminal (DVI-D 24 Pin)