Installing the Projector
Precautions for Installation
Please read the following properly when installing the projector.
Installation Environment
Please do not install or use this projector in the follow- ing places as it is a precision device. This could cause fire or a malfunction.
•Where there is water, humidity or dust.
•Where the projector may be subjected to oil, smoke or cigarette smoke.
•On a soft surface such as a carpet or cushion
•Where the projector may be subjected to direct sunlight.
•Where temperature is high or low.
Allowable operation temperature range : +5˚C to +35˚C
Allowable relative humidity range | : 20% to 80% |
| (no condensa- |
| tion) |
Allowable storage temperature range | : |
•Any room in which there is smoke and grease.
Even where smoke and grease level is minimal, prolonged exposure would affect the projector. The projector emits heat and cools the optical components down by taking in large amount of air. When the optical path is soiled by grease/dirt, images become dark and color projection de- teriorates, such often being the cause of damage. Re- moving grease/dirt totally from the optical parts is not pos- sible.
Precaution for Usage
This projector uses a
Please DO NOT use it in the following ways as it may result in fire or malfunction.
•Lay the projector on its side when projecting.
•Project outside the specified angle.
Do not use the projector while it is set more than ±5˚ horizontally (left/right), or more than ±25˚ vertically (up/ down). This could cause color variation or shorten the lamp life.
•Block the exhaust vents.
Minimum Space Required
150mm
300mm | 300mm |
150mm
500mm
Do not use a cover which may enclose the projector
Adjusting the Inclination of the Projector
The vertical angle and leveling of the projector can be adjusted with the adjustable feet at the bottom of the projector.
Vertical angle adjustment range
+6˚ 
Adjusting the vertical angle of the projector
While pushing the lever upward, raise the projec- |
|
tor. The maximum extension is approximately |
|
31mm.To retract the foot, push the lever and lower |
|
the projector slowly; the projector is fixed at the | Foot |
position where you release the lever. | Lever |
Front Adjustable Foot
Adjusting the level of the projector
Lift the projector, rotate the front adjustable foot, and adjust the horizontal angle until the projector is level.
Extend 
Shorten
14
