Basic Operations
5. Adjusting the Sound Volume
To increase the volume: press VOLUME ª (0 ➞ 50)
| To lower the volume : press VOLUME · (50 ➞ 0) |
VOL. | VOLUME |
STAND BY
LAMP TEMP OPERATE
PCVIDEO
VOL. |
MENUEXIT
ENTER
OPERATE
5
Projector: | Remote Control |
Control panel | Unit |
12 |
Screen display
When “Menu display” (☞ page 38) is set to “15sec”, after pressing the VOLUME button, the sound vol- ume display will appear on the screen for about 15 seconds. (Press EXIT button to immediately remove the
Audio-Vol
OPERATE
PC VIDEO
W
| S |
| FREEZE |
VOLUME FOCUS | QUICK ALIGN. |
MENU | EXIT |
ENTER |
|
OPERATE
5
Note
•When the sound volume is displayed on the screen, pressing the PRESET button will reset the set value to “0”.
Power Off
1. Press the OPERATE button on the projector (or the OP- ERATE button on the remote control unit ) for 1 second or more.
The OPERATE indicator will disappear, the STAND BY indicator starts to blink , and the projector goes into the
●The STAND BY indicator will continue blinking for approximately 90 seconds as the temperature of the light source lamp cools (Cool Down Mode)
PRESET | HIDE |
OPERATE
| OPERATE |
Projector: | Remote Control |
Control Panel | Unit |
Turn off Turn on
STAND BY
LAMP TEMP OPERATE
Projector: Indicator part
Note
•The OPERATE button will not work for approximately 1 minute from when the
Caution
•Please do not pull out the plug from the power source when the STAND BY indicator is blinking. It will shorten the life of the lamp and cause malfunction.
26