7.2Installation
The machine must be installed on a firm and level floor. Adjust feet until planing beds are level. All four feet must evenly rest on the floor to prevent rocking.
7.3Connection to Power Mains
-Check if voltage of power mains matches with voltage stated on machineÕs type plate (400 V 50 Hz ±5%).
-This machine must be operated on a residual current device (RCD) of 30 mA capacity , having a fault current breaker.
-The outlet this machine is connected to must be earthed and each phase protected by a 16 A
-This machine must be safety earthed. The yellow/green lead is the earth conductor. If a plug matching your local standard outlet is fitted to the power cable, do not connect the earth lead to one of the current conducting leads.
-Do not operate this machine with a damaged power cable. Risk of electrical shock.
-Worn or defective cables must be replaced immediately. Have replaced by a qualified electrician only.
7.4Direction of Rotation
Important! The direction of rotation of the cutterblock must be against the feed direction. It is factory set on
7.5Dust Collection
If this machine is operated indoors for more than 30 minutes a day it must be connected to a dust collector (the dust of oak and beech is classified as cancer causing). The dust collector this machine is connected to must provide for a minimum air flow rate of 16 mtr/sec.
The dust collection port of the dust chute has a nominal diameter of 100 mm.
7.6Automatic Dust Collector Starting
The electrical connection of this machine must ensure that a dust collector connected to it automatically starts when the machine is switched on, and provide for 20 sec
8 Safety
-Adhere to the instructions, the safety rules in particular.
-Disconnect from power (pull plug form outlet) before servicing.
-Check guards daily as per para. 14 of this manual.
-Never reach into feed openings while machine is running. Observe warning label with
-Follow instructions for fence and guard setting (para. 12.4 and 12.6).
-Do not use planer blades of less than 22 mm width.
-Dust collection as per para. 7.5 of this manual must be provided for.
-Do not work stock larger than the max. workpiece dimensions as per para. 9.
-Never operate machine without cutterblock guard in place.
-Replace damaged parts and safety guards at once with genuine metabo parts.
-Person under the age of 16 are not permitted to operate this machine.
-In case of disturbances always let the cutterblock come to a complete standstill before checking the machine.
-Always have guard and fence set for the job on hand.