12 Controls
12.1Switch Terminal/Electrical Equipment
The raised switch panel can be turned to point towards the operator position for easy access. Turn rotary switch clockwise to start machine, turn coun-
Three limit switches, located behind the thicknesser drive gear cover, pre- vent the starting of the machine if it is not properly set for the planing or thicknessing mode. The limit switches will also switch the machine off if
-the planing beds are swung up
-the chip ejection hood is swung from the cutterblock when thick- nessing
12.2Switch/Overload Protection
The switch is equipped with a
12.3Motor Brake
The motor supplied with this machine is equipped with an
12.4Canting Fence Adjustment
A
B
Loosening the ratchet lever (A) al- lows for lateral adjustment of the fence carrier.
After loosening both ratchet levers (B) the fence can be set from the 90° position to the 45° position.
When changing from planing to thick- nessing mode the fence is swung up.