INSTALLATION
CABLE INSTALLATION (INTERFACE SPECIFIC)
IBM 46XX
The following steps describe how to properly install the cables for an IBM 46xx scanner application. The scanner must then be configured to match the host’s IBM 46xx parameters. Cable installation alone does not guarantee that the scanner will communicate properly with the host system.
Configuration bar codes are located in the MetroSelect Configuration Guide (MLPN
1.Turn off the host system.
2.Plug the
3.Connect the other end of the IBM cable to communication port 9 on the host device.
Before continuing verify that the IBM cable is connected to the appropriate interface socket on the scanner. An incorrect cable connection can cause communication problems or potential damage to the scanner and/or terminal.
Manufacturers Note: Plugging the scanner into the serial port of the host device does not guarantee that scanned information will appear at the host device. A software driver and correct configuration settings are also required for proper communication to occur.
4.Plug the external power supply (MLPN
Check the AC input requirements of the power supply to make sure the voltage matches the AC outlet. The outlet should be located near the equipment and be easily accessible.
Metrologic recommends using a switched AC outlet. The switch should be located on the operator’s side of the checkout counter in close proximity to the scanner to facilitate calibration and service of the unit.
5.Connect AC power to the transformer. If the AC outlet is equipped with an on/off switch, turn the power on.
6.Turn on the host system.
7.Configure the scanner to match the host system’s IBM 46xx parameters.
Refer to the MS2xxx Stratos Series Configuration Addendum (MLPN
Bar Codes: IBM 3rd Generation Communication Defaults and IBM 3rd Generation Protocols.
Additional general configuration bar codes can be found in the MetroSelect Configuration Guide (MLPN
20
