13
☞Remove the adhesive tape from the top of the box and fold the top flaps of the box outwards.
☞Remove the two polystyrene corner blocks and remove the accessory box. The accessory box is located at one
end, on the rear side of the monitor.
Before removing the monitor from its box, assemble the table-foot1), the wall bracket1) or the glass con-
sole1) and place it in the intended installation position.
Never attempt to lift the monitor on your own, since this can cause injuries. Always obtain assistance
from a second person when removing the monitor from its box.
☞Never stand the monitor directly on its base, since the infrared sensor is mounted there and will be
damaged.
4.2 Wall Mounting (possible only with the wall bracket 1))
Non-compliance with the following instructions can result in serious injuries to persons and/or irrepa-
rable damage to the monitor.
The TFT monitor may be mounted only on a vertical wall, using the wall bracket1).
Always obtain assistance from a second person when installing the wall bracket and placing the
monitor on it.
• Take great care when installing the wall bracket, since it must not only support the weight of the monitor but also
withstand vibrations, shocks, etc.
• Before installing the wall bracket, check the thickness and stability of the wall. Purchase suitable metal screws
and wall plugs from a DIY shop. We recommend using screws with a diameter of 8 mm.
• The wall must be solid (made of normal bricks, lime sand bricks or concrete) and capable of supporting the
weight of the monitor.
• For walls made of other materials, such as wood, and for hollow walls, have the wall bracket installed by an
experienced handyman.
Wall mounting with the wall bracket 1)
• The wall bracket1) consists of two vertical metal strips, connected together by horizontal strips, and provides the
connection between the monitor and the wall.
• A drilling template can be found in the accessory box. Use this template to drill the necessary holes and secure
the wall bracket to the wall. The manufacturer recommends using screws with a diameter of 8mm.
• Note that the monitor will sink by about 19 mm, compared with the position of the bracket, when it is mounted
on the bracket.
• After installing the bracket, check that it is securely mounted.
• After the bracket1) has been installed, you can hang the TFT monitor on it.
☞There are four mounting studs on the back of the monitor. Insert all four studs into the large round openings in
the wall bracket and lower it so that the studs slide into the U-shaped slots.
1) Accessory
Glass console
Mounting stud
Wall bracket
Table foot