3.3 Keys and Functions of the Remote Control
Programming the remote control for the individual devices
Before you can control your AV devices with the remote control, you must enter a
•TV (TV set)
The TV control level is already programmed for this Metz TV set. No other code can be entered.
•VCR1 (video recorder 1) VCR 2 (video recorder 2) DVD player
HiFi (amplifier, tuner, tape deck, etc.)
The remote control must be programmed with the appropriate code numbers, as shown in the code list.
☞See the factory settings and the code list at the end of these operating instructions.
Programming the codes for VCR and DVD
☞After execution of the steps a). . . c), you have about 15 seconds to enter the code. After this, the TV automatically returns to the TV level.
a) Use the Select key | to select the desired operating level. The LED for the selected level lights. |
b)Press and hold the keys 
und
c)Enter the desired code (see the code list) with the numeric keys. If the code is accepted, the LED again blinks twice. If you have entered an invalid code, the LED lights once for about 2 seconds.
Programming the codes for CD player, tuner and tape deck
☞After execution of the steps a). . . c), you have about 15 seconds to enter the code. After this, the TV automatically returns to the TV level.
a) Use the Select key | to select the desired operating level. The LED for the selected level lights. |
b)Press and release the 
key and then press and hold the key:
F | for a tuner (radio) |
M/S | for a tape deck (cassette player) |
until the LED blinks twice.
c)Enter the desired code (see the code list) with the numeric keys. If the code is accepted, the LED again blinks twice. If you have entered an invalid code, the LED lights once for about 2 seconds.
Programming the code for a HiFi amplifier
☞After execution of the steps a). . . c), you have about 15 seconds to enter the code. After this, the TV automatically returns to the TV level.
a) Use the Select key | to select the HiFi operating level. The HiFi LED lights. |
b)Press and release the 
key and then press and hold the M/S key until the LED blinks twice.
c)Press the
d)Enter the desired code (see the code list) with the numeric keys. If the code is accepted, the LED again blinks twice. If you have entered an invalid code, the LED lights once for about 2 seconds.
Searching for the code
Proceed as described above for VCR, DVD, CD, tuner, tape deck up to the point where the code number is to be entered. Now enter "001" as the code for the search operation. The LED then blinks twice as an acknowledge- ment of the input. Press and hold the Search key (which depends on the operating level; see the table) until the search stops or the TV is switched off (a STOP or OFF command is automatically generated every 1.5 seconds).
Release the Search key and press the Select key | to confirm the selection (the code which was found is saved). |
After completion of the search, or after all code numbers have been interrogated, the related LED blinks five times.
10
