Metz 40 TK 81 manual Connecting and Switching On

4.3 Connecting and Switching On

Connecting (see the picture on page 8 for an overview of the connections)

☞Insert the mains cable into the input socket on the monitor and plug the other end into an outlet socket.

• Cable outlet or terrestrial antenna

If you have a cable outlet or a terrestrial antenna, connect it to the socket ANTENNA.

•Satellite receiver

If you have a satellite receiver, use a SCART cable to connect it to the socket SCART 1 or SCART 2.

•PC

To connect your PC to the TFT monitor, use the PC DVI-I socket. If your PC has an analogue VGA output, use the enclosed cable (DVI-I to 15-pin HD- Sub) to connect it to the monitor.

On some older PC graphic cards, pin 9 of the connector may be blanked off. If this is the case, please contact your local dealer.

Preparation

• Remote control

☞Open the battery compartment on the back of the remote control and insert the two batteries supplied with the monitor (type LR03 Micro AAA). Observe the battery polarity shown on the bottom of the battery compart- ment. Close the battery compartment again.

Switching on

☞Set the mains switch on the back of the monitor to the position "I". The monitor is now in standby mode

and can be switched on with the remote control.			RK 14
• Cable outlet or terrestrial antenna			￿
☞ Switch on the monitor by pressing the TV key or one	TV	AV	PC
of the numeric keys on the remote control.
	–/––	F	M/S

14