6.Setting Scanner and Camera Properties

6.1Displaying Scanner and Camera Properties

Double-click the [Scanner and Camera] icon on the [Control Panel] to display the corresponding Properties dialog box.

If the scanner driver has been properly installed, the icon of your scanner is displayed. Select the model name, then double-click the icon or select the [Properties...] by using right-click. The Properties dialog box shown below is displayed.

In this dialog box, the scanner can be checked and information related to different kinds of related devices can be confirmed. An explanation of each tab folder and its use is below.

*Close the application software, which is using the scanner, to display Properties dialog box.

*Depending on scanners, [Events] and [Device Set] tab may not be displayed.

*For some scanner models, only [General], [Events] and [Color Management] tabs may be displayed. Use the [Software Operation Panel] to check device information and configure device settings for such models.

For information about the Software Operation Panel, refer to the “Operator’s Guide” bundled with the scanner.

6.2General Tab

General information on the driver for a connected scanner can be displayed, and the connection can be tested from this folder.

98