Changing the door hinging

￿Lift the plugs ￿ out of the door bearing bushing in the appliance door and place it on the other side.

Mounting the bottom door of the appliance:

￿Remove the cover ￿ towards the front.

￿Pull the cover ￿ off.

￿Screw the adjustment foot at the bearing pin ￿ completely in.

￿With the assistance of another person, carefully tilt the appliance backwards and pull the bearing pin ￿ down and out.

￿Pay attention to the hinge bushing ￿.

￿Loosen the screws ￿ and remove the hinge bracket ￿.

￿Remove the cover ￿ and loosen the screw. Attach both to the other side.

￿Screw the hinge bracket ￿ onto the other side with the two outer screws. Do not use the middle screw; this allows later alignment of the appliance door using the outer, elongated holes!

￿Unscrew the bearing part ￿ from the hinge bracket ￿, turn it 180° and screw it into the opposite hole of the hinge bracket.

￿Now place the cover ￿ on the other side.

￿With the assistance of another person, carefully tilt the appliance backwards and insert the bearing pin ￿ into the hinge bracket ￿ from below. The groove in the bottom of the hinge bracket faces forwards.

￿Place the hinge bushing ￿ onto the bearing pin ￿.

￿Put the cover ￿ on.

￿Place the lower door of the appliance onto the bearing pin ￿ from above.

￿Close the bottom door of the appliance.

61

Page 61
Image 61
Miele KFN 14943 SDE ED installation instructions Mounting the bottom door of the appliance