Installation
^Draw a line inside the housing unit to mark the middle of the unit as illustrated. 
^Position the fitting bracket on this middle line. Use the indented mark on the bracket to guide you.
^Fit one screw a into the centre of the first long slot.
^Check the alignment with the front edge of the unit and with the middle line, and then fit another screw a into the other long slot.
^Then tighten both of these screws.
^Place the appliance in the housing unit and using your hands push on both sides of the back of the oven interior to move the appliance into position. It will engage in position when it is correctly installed.
^Check that it is correctly aligned.
^If it is not aligned correctly, carefully pull it back out of the niche and realign it by slightly adjusting the position of the bracket on the long slots.
^When correctly aligned, insert the third screw a into the middle of the bracket to prevent the bracket moving out of position.
^Slide the appliance into the housing unit, and pull the cable with the plug* through the back of the unit.
*Plug shown is for illustration purposes only.
55
