Miele Premier 300 operating instructions IAdd detergent, Liquid detergent, JPress the Start button

How to wash correctly

IAdd detergent

It is important to dispense the correct amount, because . . .

. . . too little results in the following:

–Laundry will not be properly clean and will in time become grey and hard to the touch.

–Greasy particles cling to the laundry.

–Limescale deposits on the heater elements.

. . . too much results in the following:

–Excessive foam which causes a low level of agitation and poor wash, rinse and spin results.

–High water consumption (an additional rinse cycle will automatically switch in).

–A burden to the environment.

Liquid detergent

Liquid detergent should be dispensed using a ball provided by the manufacturer for programmes without a pre-wash.

For programmes with a pre-wash you will need to purchase a special container from the Miele Spare Parts department which sits in the main wash compartment j of the detergent dispenser drawer. Add liquid detergent to this container for the main wash and to compartment i for the pre-wash.

^Pull out the detergent drawer and place detergent in the compartments as follows:

i= Detergent for Pre-wash

(if selecting Pre-wash, add 1/4 of the total amount recom- mended). This compartment is also used for starch formula- tions when starching separately.

j= Detergent for the main wash including Soak

§= Fabric conditioner or liquid starch.

^Close the detergent drawer.

See section on "Detergent" for further information on detergent and the amount to dispense.

JPress the Start button.

This starts the programme.

23