Settings menu J
Buzzer
The buzzer has two volumes.
Normal (Factory default)
The buzzer sounds at the end of a programme.
Loud
The buzzer sounds at maximum volume at the end of a programme.
A tick L will appear beside the option to show that it has been set.
Keypad tone
An audible tone sounds each time a button is pressed.
A tick L will appear beside the option to show that it has been set.
Factory default: Off.
Contrast
Brightness
There are ten different display contrast and display brightness settings.
The bar chart shows you the setting. Factory default: a medium setting.
Standby display
To save energy, the display goes out after 10 minutes and the indicator light for the Start/Stop button will start flashing slowly.
There are two options:
On
Standby is activated:
–if a programme is not selected within 10 minutes of the tumble dryer being switched on.
–10 minutes after a programme has started.
–10 minutes after the end of a programme.
Not in current prog. (Factory default)
–Standby is activated if a programme is not selected within 10 minutes of the tumble dryer being switched on and after the end of a programme. (Standby is not activated after a programme has started).
Pressing one of the buttons switches the display back on again.
A tick L will appear beside the option to show that it has been set.
Memory
The electronics will memorise the drying level and any extra options selected for the current drying programme.
A tick L will appear beside the option to show that it has been set.
Factory default: Off.
59
