Installation
For right hand hinging only:
–front panel shown decor side face down, upper edge at the bottom:
if width (b) increases, measurement a must also be increased
b = 592 mm N a = 21.5 mm b = 593 mm N a = 22.0 mm b = 594 mm N a = 22.5 mm b = 595 mm N a = 23.0 mm b = 596 mm N a = 23.5 mm
H = height of adjacent furniture unit doors.
C Drill the two hinge holes (C 35 mm/15.5 mm deep) in the back of the front panel.
D Next, drill the four smaller holes
(C 7 mm/10 mm deep) in the back of the front panel.
E Shorten the front panel from the bottom to height H.
Preparing the fixing points
F Hold the
G Mark the fixing points on the back of the front panel through the holes in the machine door plate (see arrows in the illustration).
H Remove the front panel.
I Now drill holes (C 2.5 mm/10 mm deep) in the back of the front panel.
46
