Installation

Fitting a door front panel made by another manufacturer

Preparing the front panel

A Measure distance X for drilling the hinge holes.

– with spacer bars:

– without spacer bars:

(the front panel must be correspondingly higher)

B Mark the two hinge holes and the four smaller holes as shown in the diagram.

For left hand hinging only:

front panel shown decor side face down, upper edge at the bottom:

if width (b) increases, measurement a must also be increased

b = 592 mm N a = 21.5 mm b = 593 mm N a = 22.0 mm b = 594 mm N a = 22.5 mm b = 595 mm N a = 23.0 mm b = 596 mm N a = 23.5 mm

H = height of adjacent furniture unit doors.

45

Page 45
Image 45
Miele T 4839 Ci operating instructions Fitting a door front panel made by another manufacturer, Preparing the front panel