Cleaning and care
Cleaning the water inlet filters
The washer has two water inlet filters to protect each inlet valve. These filters should be checked and cleaned if necessary every 6 months. This may need to be done more frequently with some water supplies.
Turn off the water supply.
Unscrew the inlet hose from the valve |
|
|
|
by turning the connector counter- |
|
|
|
clockwise using a wrench if |
|
|
|
|
|
| |
necessary. | Remove the rubber seal, 1, from the | ||
|
| connector. | |
| Using needle nose pliers, grasp the | ||
|
| plastic filter, 2, and pull it out of the | |
|
| hose connector. | |
| Clean the filter under running water | ||
|
| and carefully remove any large | |
|
| particles. | |
| Replace the filter and seal then | ||
|
| reconnect the hose. | |
| Slowly turn on the valve and check | ||
|
| for leaks. If water leaks, tighten the | |
|
| bolt. | |
|
|
|
|
|
|
|
|
|
| Both filters must be put back in |
|
|
| place after cleaning. |
|
|
|
|
|
|
|
|
|
29
