4-9. Installing And Threading Welding Wire
. Hold wire tightly to keep it from unraveling.
3
12
6 in 
(150 mm)
Pull and hold wire; cut off end.
Tighten
Clockwise
WOOD
Installing Wire And Adjusting Hub Tension:
1Retaining Nut
2Hub Tension Adjustment Knob
Remove retaining ring, and install spool so hub pin fits spool hole. Re- install retaining nut.
Adjust tension knob so only a slight force is needed to turn spool.
Threading Welding Wire:
3Pressure Assembly Adjustment Knob
Lay gun cable out straight.
Open pressure assembly, hold wire tightly, and cut off end. Push wire through guides into gun.
Close and tighten pressure assem- bly. Press jog switch until wire comes out gun.
Feed wire against wooden surface, and tighten knob so wire does not slip.
Cut off wire, and close door.
Ref. 804
