Miller Electric MOG-400, MOG-300, MOG-350, MOG-250, MOG-Pak, RGC manual Tools Needed

3-3. Weld Input/Output Cables For Resistance Grid (Dual Model Shown)

9

8

4

1

28

10

5

11

3

67

Or

Tools Needed:

YTurn Off welding power source, and disconnect in- put power before making any weld output connections.

1Weld Input Cable

2Work Cable

3Weld Output Cable

If necessary, use Section 3-7 to select proper cable size.

Use shortest cables possible.

Do not use damaged cables.

4 Terminal Lug

Use lugs of proper amperage ca- pacity and hole size for connecting to common work, electrode hold- er(s), and weld output terminals (if applicable).

5 Common Work Connection

Connect work cable to common work according to codes.

6Insulated Electrode Holder

7GTAW Torch

Install according to manufacturer’s instructions.

8 Female Camlok Connector

Install onto weld input cable as shown in Section 3-5.

9 Weld Input Receptacle

Connect cable to weld input recep-

4tacle on rear panel of grid.

10 Male Camlok Connector

Install onto weld output cable as shown in Section 3-6.

11 Electrode Receptacle

Connect electrode holder cable to Electrode receptacle.

S-0793

OM-808 Page 12