Miller Electric R-115 manual To Terminal E Lead, For Welding power sources

3-13. Connection For Hobart Welding Power Sources With 5-Socket And 115 Volt AC Receptacles

				. Make ground lead connections
				according to Section 3-9before
				following this procedure.
				1
			E
A	B	C	D	3
					E
				D	A
				C	B
4
				2
Tools Needed:
			1/4 in

1Terminal Block 1T

23-Conductor Cord

32-Conductor Cord

4Green Lead (Connected To Ground In Section 3-9)

Connect remaining leads to terminal block as follows:

A:115 VAC/Neutral Lead

B:115 VAC/Hot Lead

C:No Connection

D:Dry Contact Closure w/Respect To Terminal E Lead

E:115 VAC/Contact Closure Lead

.For welding power sources

requiring dry contact closure, move lead 38 at terminal block to terminal D.

Secure strain relief clamp around cords.

Reinstall and secure wrapper to unit.

Connect remaining cord ends to welding power source.

Ref. 802 310 / Ref. 193 749

3-14. Connection For Lincoln Welding Power Sources With 14-Socket Receptacle

	. Make ground lead connections				1	Terminal Block 1T
					2	Interconnecting Power Cord
	according to Section 3-9before
					3 Green Lead (Connected To
	following this procedure.
						Ground In Section 3-9)
					Connect		remaining	leads	to
					terminal block as follows:
					A: 115 VAC/Neutral Lead
	3				B: 115 VAC/Hot Lead
					C: No Connection
	E
C	D				D: Dry Contact Closure w/Respect
						To Terminal E Lead
B
A					E: 115 VAC/Contact Closure Lead
1			H		. For		welding power sources
	F	G		I	J	requiring dry contact closure,
		M	N	K		move lead 38 at terminal block
	E		L		A	to terminal D.
		D	C	B	Secure strain relief clamp around
					cord.
	2				Reinstall and secure wrapper to
					unit.
					Connect remaining end of cord to
Tools Needed:					welding power source.
	1/4 in
							Ref. 802 310 / Ref. 193 749
OM-193 471 Page 16