26
5-2-5 When From external system Method is used (1) When the energy-save level is set to 0 (It is always set to level 0 in an energy-save control method) ,
energy-save control will not be performed for the indoor units that show a gre ater differenc e between the
set temperature and indoor temperature than the value s et in the window on the right.
Make the setting when some type of energy-saving control is ef f ec tive at e ner g y-save level 0 and the level
of comfort is high on priority list. (Choose between 3 to 9)
Make the energy-save control setting for the outdoor units f or each energy-save level.
Note: M-NET addresses are displayed on outdoor units of City multi type. M-NET addresses and group names are displayed on
A-control units (Slim units).
Note: As for A-control outdoor units, only the inverter models can be put on the energy save control. Do not make the energy save
settings for the constant speed models.
(1) Set the maximum operating capacity at each level .
Normally, outdoor units operate at 100% capacity.
The smaller the maximum operating capacity, the
more energy will be saved.
Note: Energy-saving effects cannot be expected when the
outdoor units are running with low load and are
operating below the set capacity level.
Note: Do not use the capacity-save control with
heat-accumulating units (ICE-Y) or Multi S units. On
these units, always set the capacity to “100%.”
(2) Set the control time at each level. When a c apacity-save control over outd oor units is performed, it is
recommended that the control time be set to eit her 30 or 15 minutes, for shorter control tim e is not likely to
bring much benefit.
If any time other than “30-minute” is selected, the control is done on r otation so as to avoid the overlapping
of control time of the connected outdoor units as much as pos sible.
(3) To copy the settings for a certain outdoor unit to an other outdoor unit, click [Copy] so the selected item s are
shown in yellow-green, and click [Paste] on the screen for the target outdoor unit.
To make settings for all the outdoor units at once, check [Batch O perations], and enter the settings.
Uncheck [Batch Operations] by clicking on the box again to enable the individual s etting of the outdoor
units.
Cop
y
Click to copy the settings. Paste
Click to paste the settings.
Batch Operations
Used to make settings for all
outdoor units at once.
Control Level
Control Time
Select the control time.
Maximum Capacity
Select the upper limit of outdoor
unit operating capacity.
Capacity
80%
Maximum Capacity at 80%
Capacity
Value
No energy-saving
effects
Amount of saved energy
With energy-saving effects
Time