Mitsubishi Electronics WD-62527, WD-62528, WD-52528 Connecting VCR Video and Audio to a Cable Box

Connecting VCR Video and Audio to a Cable Box

VCR Video and Audio to a Cable Box

Figure 6

A two-way RF splitter, 4 coaxial cables, right and left audio cables and an S-Video or Video cable are required. These are not included with the TV.

1.Connect the incoming cable to IN on the RF splitter.

2.Connect one coaxial cable from OUT on the RF splitter to ANTENNA IN on the cable box back panel.

3.Connect one coaxial cable from OUT on the RF splitter to ANT-1 MAIN on the TV back panel.

4.Connect one coaxial cable from OUT on the cable box to ANTENNA IN on the VCR back panel.

5.Connect one coaxial cable from ANTENNA OUT on the VCR back panel to ANT-2 AUX on the TV back panel.

6.To use the TV speakers with the VCR, connect a set of audio cables from AUDIO OUT on the VCR back panel to INPUT-1 AUDIO-LEFT (MONO) and AUDIO-RIGHT on the TV back panel. The red cable connects to the R (right) channel and the white cable connects to the L (left) channel. If your VCR is mono (non-stereo), connect only the white (left) cable.

7.Connect either an S-Video or Video cable from VIDEO OUT on the VCR back panel to INPUT 1 VIDEO on the TV back panel. Only one type of video cable should be connected. S-Video is recommended, if available.

8.For NetCommand® controlled recordings, connect a set of audio cables from AUDIO IN on the VCR back panel to RECORD OUTPUT AUDIO-LEFT (MONO) and AUDIO-RIGHT on the TV back panel. The red cable connects to the R (right) channel and the white cable connects to the L (left) channel.

9.Complete the NetCommand controlled recordings connections by connecting a Video cable from VIDEO IN on the VCR back panel to RECORD OUTPUT VIDEO on the TV back panel.

Note: With this connection configuration, it is possible to view live cable programs through the VCR. For best picture quality, however, always view live cable programs directly from the cable box instead of the VCR.

57 CBDL QBOFM

INPUT

COMPONENT

YPbPr (480i/480p/720p/1080i)

3

1

2

1

2

Y

INPUT

OUTPUT

47JEFP SFDPNNFOEFE JG BWBJMBCMF

DVI



AUDIO

RECORD



S-VIDEO

Analog Audio

OUTPUT

OUTPUT

"UUBDI POMZ POF DBCMF UZQF

Pb

1

2

VIDEO

VIDEO

Pr

AUDIO-

LEFT/



AUDIO-

(MONO)

AUDIO-



LEFT/

LEFT/

AUDIO-

(MONO)

(MONO)

RIGHT

AUDIO-

AUDIO-



RIGHT

RIGHT



7$3 CBDL QBOFM

)46



DIGITAL

AUDIO



CableCARD™ USE WITH ANT 1 CARD TOP



1 / MAIN

ANT 2 / AUX

OUTPUT

IEEE 1394

INPUT/

OUTPUT

*G ZPVS 7$3 IBT B WJEFP DIBOOFM



PS 3' 0/0'' TXJUDI TFU JU UP 0''

$BCMF #PY

065 065

41 8": 580-*55&3



*ODPNJOH $BCMF

CBDL QBOFM TFDUJPO







*/





*/

065



Figure 6. Connecting a VCR to a Cable Box

Note: NetCommand® will assume your VCR is connected to inputs as shown on this page. If you use any other inputs for your VCR or add a second VCR, this change must match in the NetCommand system. See Edit

NetCommand... in Chapter 3 for more information.

Chapter 2. Connecting 27