Motion MMI-8S installation manual

!!!! ATTENTION !!!!

Mis-wiring of motor or power supplies WILL damage motor drivers IMMEDIATELY. Motor coils A or B can be reversed; motor will run in the opposite direction. Pairs can be reversed; pair A in coil B for example. CROSS-WIRING, an A and B wire crossed, WILL damage driver. Allowing exposed motor leads to touch each other, ground, or power MAY damage driver. Refer to Appendix D in the MS driver section for wiring schemes.

SMOKE, POPPING, ELECTRONIC ODOR, OR FUSE FAILURE

INDICATES DRIVER FAILURE.

Call the Service Center. Do NOT change fuse or attempt repair without instructions.

ADDITIONAL DAMAGE CAN OCCUR !!! Shorted drivers can easily be repaired by replacing the

socketed driver arrays.

!!!! WARNING !!!!

NEVER connect or disconnect any of the motor leads or power supply (VMM) leads before disconnecting AC power! Unit may be safely operated WITHOUT motor. However, pause 30 seconds after power off before reconnecting motor (Bleed-Down time).

NOTE !

An understanding of the Cybernetic Motion Controller and its Command Set is required in the following explainations . Refer to the Cybernetic Micro Systems - CY 545 OR 550 Step Motor Controller Manual.