Motorola 305 manual Book Page 14 Tuesday, April 15, 2003 1115 AM

305.book Page 14 Tuesday, April 15, 2003 11:15 AM

2

sure to do this accurately and without a long delay. If programming the AUX key for a satellite receiver use one of the following SAT codes: 000, 001, 002, or 003.

7.If the remote control "accepts" the code, you will see several rapid flashes of the light. If it does not flash, repeat steps 4, 5 and 6. After the remote control accepts the code, press the POWER key on the remote control to make sure the remote control is able to turn your component off. This means it is functioning properly.

8.If your component does not respond to the remote control POWER key, even though it has "accepted" the manufacturer’s code, repeat steps 4, 5, and 6 using the second three-digit code from the table. If this does not work, try the third code, etc., until the remote control accepts the code and your component responds to the remote control POWER key.

NOTE: Some cable box brands are also programmable using these instructions. Check the table that appears later in this section for applicable cable box brands and codes. You will press the TV key to program your cable box. Your remote can only accept a TV or cable box code for this programming step.

If Your Remote Control Cannot Find a Working Three-

Digit Code in the Tables (Scanning)

If you try to program your remote control using the three-digit codes, and the remote control does not work correctly, you may be able to find a code that works by using the "scanning" process.

1.Turn on the TV or the VCR-depending upon whether you wish to program the remote control for your TV or for your VCR.

2.Press the TV key (or VCR key) for at least three seconds or until the LED blinks.

3.The following steps explain how to "scan" through the TV (or VCR) codes

stored in your remote control using thevkeys. (The LED will not be lit while thevkeys are depressed.

-While pointing the remote control at your TV (or VCR), press the 5 key to scan upward to the next code. (Use the6key to return to the previous code.)

-If the transmitted code is the correct one, your TV (or VCR) will turn off, responding as if its POWER key were pressed.

-If your TV (or VCR) does not respond, depress the5key to try the next code. When your TV (or VCR) turns on or off as a result of the

transmitted code, you will know that you have found the correct code.

-When you have found the correct code (power to your TV or VCR is

14