•Replace the base cover on all of the backhaul modules.
Alignment
•If the backhaul modules are not utilizing passive reflectors, then visually align the units.
•If the backhaul modules are utilizing passive reflectors then visually align if possible or utilize compass headings and initiate step 1 in the following process:
1.Lock down timing master module
2.On the timing slave module, utilize RSSI only mode of alignment web page:
•Choose the frequency to monitor from the pick list (this would be the same frequency that the backhaul timing master module is transmitting on)
•Click the radio button to highlight “Enable” on RSSI Only mode
•Click “Enable Aiming Mode”
The module will now report back the level of RF energy present at that specific frequency. To refresh the screen, click the Enable Aiming Mode button as appropriate or configure the web page
3.When RSSI value is above minimum, disable RSSI Only mode and monitor the Status web page:
a.Watch for “Syncing”, then “Registering”, then “Registered”. When the unit is registered, move on to Step 4.
4.While monitoring RSSI and Jitter, at the incrementally move the timing slave module in the vertical plane. Observe where the values are at their best and lock down the unit. Now, incrementally move the timing slave module in the horizontal plane. Observe where the values are at their best and lock down the unit. Alignment is complete when reported values are at their best and the unit is registered.
5.If necessary, incrementally move the timing master module a couple
Backhaul User Manual Issue 3 | Page 25 of 53 |
