I n s t r u c t i o n s : P o w e r , V o l u m e , M u t e , T V I n p u t
seconds (until the red light at the end of the remote lights up and stays on when you release the buttons).
To Control: | TV power, volume, | TV input only | A/V system | A/V system | |
mute, and TV |
| power | volume and | ||
|
| ||||
| Input |
|
| mute | |
|
|
|
|
| |
Press the: | TV PWR and TiVo | TV INPUT and | TV PWR and TiVo | MUTE and TiVo | |
buttons | TiVo buttons | buttons | buttons | ||
| |||||
|
|
|
|
|
2.Enter the search code. Refer to the table below and use the number keys on your remote control to enter the appropriate code.
To Test: | TV power, volume, | TV input only | A/V system | A/V system |
mute, and TV Input |
| power | volume and mute | |
|
| |||
|
|
|
|
|
Enter: | 0999 | 0999 | 1999 | 1999 |
|
|
|
| |
|
|
|
|
|
After you press the fourth digit of the code, the red light on the end of the remote | 4 |
| |
control will flash twice, then remain on. |
|
3.Test the remote control. Point the remote control at the TV or A/V receiver. Press CHAN UP to test the first code. The test is successful if the TV or A/V receiver responds (by powering off, changing input, or muting, depending on the function you are trying to program). If there is no response, wait two or three seconds, then press CHAN UP again. Continue doing this until the TV or A/V receiver responds.
When the TV or A/V receiver responds, press ENTER to select the current code. The red light at the end of the remote control will flash three times to indicate that the remote control is properly coded to control your device.
35
