T r o u b l e s h o o t i n g
•Press the TiVo button to go to TiVo Central, then select Messages & Setup, then Settings, then Channels, then Channel Changing, and select “Cable Box” or “Satellite Box.” Verify the IR code you chose during Guided Setup. See page 10 for more on choosing an IR code.
•Try using the cable or satellite box’s remote to change the channel. If it doesn’t work, contact the manufacturer or service provider for assistance.
If you have a Motorola/General Instruments DCT2000 series cable box or a DIRECTV satellite box and used the Serial Control cable:
• Make sure the cable or satellite box is turned on. |
|
• Verify that the Serial Control cable is plugged into the data connector on the cable or satellite box and into the Channel Change/ |
|
Serial connector on the back of the Recorder. |
|
• Unplug the cable or satellite box from the wall, then plug it back in. Then try changing channels with the Recorder’s remote control |
|
again. |
|
• Try using the cable or satellite box’s remote to change the channel. If it doesn’t work, contact the manufacturer or service provider |
|
for assistance. |
|
• Satellite Box Only: You may have incorrectly specified the type of program guide for your DIRECTV satellite receiver during |
|
Guided Setup. There are two types of program guides: MPG (Master Program Guide) and APG (Advanced Program Guide). During |
|
Guided Setup, you select either | 5 |
To change this option: First, unplug the power cord for the satellite receiver and plug it back in. Next, go to TiVo Central, then |
select Messages & Setup, then Settings, then Channels, then Channel Changing, and select “Serial cable.” If you originally selected
45
