5 - 4 MT2070/MT2090 User Guide

User Preferences

Set Default Parameter

You can reset the device to two types of defaults: factory defaults or custom defaults. Scan the appropriate bar
code below to reset the decoder to its default settings and/or set its current settin gs as custom defaults.
•
Set Defaults - Scan this bar code to reset all default parameters as follows.
•If you previously set custom defaults by scanning Write to Custom Defaults, scan Set Defaults to
retrieve and restore the decoder’s custom default settings .
•If you did not set custom defaults, scan Restore Defaults to restore the factory default values listed in
Tabl e A- 1.
•
Set Factory Defaults - Scan this bar code to restore the factory default values listed in Table A-1. This
deletes any custom defaults set.
•
Write to Custom Defaults - Scan this bar code to set the current decoder settings as custom defaults. Once
set, you can recover custom default settings by scanning Restore Defaults.
NOTE When programmed to do so, certain MT20X0 cradles send parameter updates to the scanner. For
example, if the user sets up custom defaults on the scanner, these settings will be overwritten on cradle
connection if Parameter Broadcast is enabled. Prior to setting custom defaults, see Modes of Operation
on page 4-19 and Parameter Broadcast (Cradle Host Only) on page 4-19 to learn about cradle and
scanner settings.
*Set Defaults
Set Factory Defaults
Write to Custom Defaults