Accessories 13 - 7

Sending Data to the Host Computer
MT2000 Series include Ethernet cradle drivers that initiate autom atically when you place the device in a properly
connected four slot Ethernet cradle. The cradle receives data fr om the device and transmits it to the host computer
via the Ethernet cable.
Prior to inserting the device in the cradle, it is recommended that you tu rn off the device’s wi-fi radio to avoid
interference. To turn off the radio, go to the Home screen on the device and select Config > Wireless Companion >
Disable Radio.
Charging
To charge the battery in the device and/or a spare battery, ensure the correct power supply is connected then place
the device/battery in the cradle (see Inserting Batteries on page 13-8). Char ging begins when the LED indicators,
on the device and in the cradle’s spare battery section, start flashing green. A complete cha rge of a fully
discharged battery can take up to four hours.
LED Indicators
Table 13-4
Device LED Indicators
LED Indication
Off No power applied to device (battery discharged or removed); device is in low power and ready to
scan; or, battery is fully charged and device is ready to scan.
Note:
The default state of the LED is off when the battery is fully charged. By modifying the
BatteryLED.reg file under the \Platform directory on the device, you have the option to enable a solid
green LED on a fully charged battery. For detailed information, refer to the MT2070/MT2090
Integrator Guide, p/n 72E-117858-xx.
Green Flash Device is charging.
Red Flash Charging problem or data transmission problem.
Table 13-5
Cradle LED Indicators
LED Indication
Solid Blue (Cradle Power LED) Cradle is powered.
Ethernet Activity LEDs
(Ethernet cradles only)
Speed LED (100/10) - Primary Port Connection
The cradle’s green Speed LED lights to indicate that the transfer rate is 100 Mbps. When it
is not lit it indicates that the transfer rate is 10Mbps.
Link LED ( ) - Primary Port Connection
The cradle’s amber Link LED blinks to indicate activity, or stays lit to indicate that a link is
established. When it is not lit it indicates there is no link.