Motorola rdm2080d, RDM2020 manual Reading Auto-Scan Values, Changing Values

2.Short press PTT button again and the radio signals the second digit “1”.

3.Short press PTT again and radio signals the third digit “8”.

Reading Auto-Scan Values

After finishing reading CTCSS/DPL codes, if you short press PTT once again, the radio takes you to Auto-Scan as per “Advanced Configuration (RDM2020 Model)” on page 44 (Step 3). Auto-Scan only has two values:

Radio Signal Value	Status
0	OFF
1	ON

Note: Auto-Scan is set to OFF by default.

Changing Values

Each time the radio signals and beeps, the current value can be changed by short pressing SB1 to increase or by short pressing SB2 to decrease. The radio will then signal the new setting it has been configured to.

To abort the value configured, turn the radio OFF or change channel using the channel knob.

If the radio “rolls-over” to the “Idle” Advanced Configuration Mode, the radio emits a “chirp” and radio LED starts blinking green again. All values that were changed are automatically saved.

ADVANCED

CONFIGURATION

47English