ADVANCED CONFIGURATION
Configuring a Frequency
Assuming current frequency value is set up to channel 1, with the MURs default frequency “1” (equivalent to 154.60000 MHz), and it will be changed to Frequency Number = “4” (which is mapped to 151.88000 MHz), follow the sequence below:
1.Enter Advanced Configuration Mode.
2.Short press the PTT button to enter Frequency Mode. Radio will signal current value “1” with one beep (a red blinks).
3.Press the SB1 button once to increase digit to “2” (two beeps & two red blinks).
4.Press the SB1 button once to increase digit to “3” (three beeps & three red blinks).
5.Press the SB1 button again to increase digit to “4” (four beeps & four red blinks).
6.Long press the PTT button. LED indicator will show a green heartbeat to indicate “Idle” state.
7.Long press the PTT button to exit Advanced Configuration Mode or turn the radio OFF.
Configuring a Code
Assuming current code value is set to factory default “001”, and it will be changed to CTCSS/ DPL Code = 103 follow the sequence below:
1.Enter Advanced Configuration Mode.
2.Short press the PTT button three times (Enter CTCSS/DPL Programming Selection Mode). Radio LED will blink orange to indicate that current value is “0”.
3.Press the SB1 button once (to change first digit to “1”) LED indicator blinks red.
4.Short press the PTT button (to move forward and program second digit). Radio LED blinks orange to indicate current value is “0”.
5.Short press the PTT button and move ahead to program the third digit. LED indicator blinks red to indicate current value is “1”.
6.Press the SB1 button to change the ‘third digit’ to “2”. Press the SB1 button to change again this “third digit” to “3”. The radio will signal the chosen value.
English 48
