Moyer Diebel MH-6LM2 To Change from Straight-through Operation to Corner Operation, B C A

INSTALLATION

To Change from Straight-through Operation to Corner Operation

The dishwasher is shipped from the factory for straight-through operation. The following instructions explain how to change the dishwasher for corner operation.

Refer to Fig. 2

1.Place the dishwasher so that operator controls are readily accessible.

2.Minimum clearance from any wall is 5-1/4" (133mm).

WALL 5-1/4"[133mm] MIN.

WALL

5-1/4"[133mm] MIN.

WALL

.MIN

1/4"[133mm]-5

POWER ON

SWITCH

FRONT

Note:

Power switch is readily accessible.

FRONT

POWER ON

SWITCH

WALL 5-1/4"[133mm]

Do not place the dishwasher closer than 5-1/4" (133mm) to any wall.

Figure 2

Placement for Corner Operation

MIN.

Refer to Fig. 3a-3b and perform the steps below.

1.Remove the front rack guide (A). Discard the square spacers.

2.Move front rack guide (A) to the right side of the rack tracks. (See Fig. 3b) Use existing hardware.

3.Unbolt the track (B) and rack support rod (C).

4.Remove and save the two remaining fasteners from rear track.

5.Bolt (B) and (C) as shown in Fig. 3b.

Figure 3

Change the Track Assembly

B C

A

Figure 3a

Straight-Through Configuration

B

C

A

Figure 3b

Corner Configuration

9