MRV Communications EM316EDFA-LPR, EM316EDFA-BR manual Front Panel, LEDs, DIP Switches

Fiber Driver® EM316EDFA User Guide

3.2 Front Panel

Figure 3 -- EM316EM316EDFA-BR / EM316EDFA-LPR Front Panel

3.3 LEDs

PWR/NMS Power	On – DC +5V power is applied to the card
SD Input Optical Power	On – Input signal greater than the input threshold
	setting
OPTICAL OUTPUT OK	On – Output power is greater than -2 dBm, for apc
Output Optical Power	mode or -10 dBm for agc mode

3.4 DIP Switches

The EM316EDFA-BR is pre-configured in booster mode. There are no user-selectable switches.

The EM316EDFA-LPR is pre-configured in inline pre-amplifier mode. There are no user-selectable switches to operate either inline or as a pre-amplifier.

The DIP switch block at the underside of the module has six switches. Only switch 6 affects operation of the amplifier module. Use switch 6 to enable or disable network management.

Switch #	Function	Setting
1-5	N/A	Reserved
6	Management Enable	Default: ON = enable management

P/N 1294008-001 Rev D2 4