Fiber Driver® EM316EDFA User Guide
5.2.3.5 Configuring System Parameters
Enter "configuration" mode, as shown below, to configure the system parameters
fiberdriver# configure terminal
Note that each command is completed with the <CR> or <Enter> key, which is not printable.
Once the mode is changed, the prompt also changes. Change the SUPER user password using the "username" command.
fiberdriver(config)# username admin password <new password>
Set the IP configuration using the "ip" command group. Set IP address and IP mask information using the following command.
fiberdriver(config)# ip interface 169.254.88.200/16
The IP address (169.254.88.200) and the netmask (16) are examples only. Use the IP address and netmask appropriate for the
Set specific gateway information using the following command:
fiberdriver(config)# ip default gateway 169.254.88.1
The IP information configured does not load until restarting the system or using the command:
ip interface update
Use the following command to save the configuration into permanent
fiberdriver(config)# write file fiberdriver(config)# exit
The system does not automatically save configurations to permanent storage. Use the write file command to save a configuration before restarting the system. Now the IP configuration is complete. The default SNMP community names are "public" for read and "private" for write.
Use the description command to change names of the chassis, slot, and port. Use the show command to verify the change. Chassis names are limited to nine characters.
P/N | 17 |
