MRV Communications EM316EDFA-LPR, EM316EDFA-BR manual P/N 1294008-001Rev D2

Fiber Driver® EM316EDFA User Guide

The boxes below illustrate two common parameters used with the show command.

Default settings are listed in the show defaults command output. These parameters reflect the module boot configuration which is determined by DIP switches and firmware programming. All lines in this display begin with “!” to indicate that they are comments for information only.

fiberdriver(slot/1.3)# show defaults slot 1.3

!description EM316EDFAv at 1.3 fiberdriver(slot/1.3)# slot 1.4 fiberdriver(slot/1.4)# show defaults slot 1.4

!description EM316EDFA at 1.4 fiberdriver(slot/1.4)#

The show config command displays the active environment settings currently in the operational context. The lines beginning with “!” are comments added for clarity in the CLI display only. The comment lines ending with “:” are headings that describe the settings listed in this display.

fiberdriver(slot/1.3)# show config slot 1.3

!Configured parameters that override defaults:

!Configured parameters that match defaults:

!Parameters that will follow defaults:

!description EM316EDFAv at 1.3 fiberdriver(slot/1.3)# slot 1.4 fiberdriver(slot/1.4)# show config slot 1.4

!Configured parameters that override defaults:

!Configured parameters that match defaults:

!Parameters that will follow defaults:

!description EM316EDFA at 1.4 fiberdriver(slot/1.4)#

The default parameter values are constant for each module, but can change to reflect DIP switch settings. Changes to these parameter values are reflected in the show config command output. Restoring the default values returns the module to its original operating state. Preserve changes made to the configuration for use in future CLI sessions and beyond a reboot by writing them to the startup-configfile as described later in this section.

P/N 1294008-001 Rev D2 24