Multi-Link Voice/Fax/Modem Call Processor manual Initial Check

2.2 INITIAL CHECK

Included with The Stick are additional items that make life a whole lot easier. Please check the box and make sure you have:

•The StickTM Voice/Fax/Modem Call Processor

•One 12 Volt Class 2 Power Source

•One Silver Modular Line Cord

If any of these items are missing, please alert the retailer from which you purchased the unit and also Multi-Link, Inc. at 1-800-535-4651

POWER UP

The first thing you must do before programming The Stick is to “power up” the unit. It is recommended that you choose a power outlet close to a

telephone wall jack. Plug the power supply (supplied) into the 110 volt outlet and insert the barrel plug into the port labeled ::

USE ONLY WITH 12 VAC 0.8-1.0A

CLASS 2

POWER SOURCE

at the rear of the unit. The red light beside “The Stick” logo should be lit at this time.

CONNECTING TO THE PHONE LINE

Before programming The Stick, you will need to install it on your existing telephone line and connect a touch-tone (DTMF) telephone to the port labeled “VOICE 1" at the bottom of the unit. A silver Modular Line Cord has

been supplied for connecting The Stick to a phone line. Plug one end of the line cord into the port labeled “LINE”. Plug the other end into a telephone wall jack. At this time you should hear dial tone when the handset on your touch tone phone is lifted off-hook.

8