Multi-Tech Systems MT56DSU-S Appendix B - Interface Signals and Connector Pinouts

1 38

Appendix

Appendix B - Interface Signals and Connector Pinouts

Pin 1 Pin 8

Key

As viewed from the rear

Figure B-1. Connector

DESCRIPTION

This connector ties the MT56DSU-S to the DDS Network. The RJ-48 connector is keyed for proper insertion

of a keyed RJ-48 plug.

PIN IDENTIFICATION

Pin Description Destination

1 Transmit Pair To Line

2 Transmit pair To Line

3 N/C

4 N/C

5 N/C

6 N/C

7 Receive Pair From Line

8 Receive Pair From Line

Contents

Main Revision Date Description Contents Page Page 1.1 Introduction 1.2 About This Manual 1.3 Description 1.4 CSU/DSU Basics 1.4.1 DSU Functions 1.4.2 CSU Functions 1.5 Features 1.6 Specifications Page 2.1 Introduction 2.2 Front Panel 2.3 Back Panel 2.3.1 POWER Connector 2.3.2 RS232 Connector 2.3.3 LINE Connector 2.4 Switch Settings 2.5 Shunts Page 3.1 Introduction 3.2 Unpacking 3.3 Telecom Safety Warnings 3.4 Setup 3.5 V.35 Shunt Page 4.1 Introduction 4.1.1 Loopback Test 4.1.2 Line Loopback Test 4.1.3 DSU Loopback Test 4.1.4 DSU Back-to-Back Test Page 5.1 Multi-Tech Systems, Inc. Warranty & Repairs Policies 5.1.1 Warranty 5.1.2 U.S. and Canadian Customers 5.1.3 International Customers (outside U.S.A. and Canada) 5.1.4 International Distributors 5.2 Repairs 5.2.1 Repair Procedures for U.S. and Canadian Customers 5.2.2 Repair Procedures for International Customers 5.2.3 Repair Procedures for International Distributors 5.2.4 Replacement Parts 5.3 Technical Support 5.4 Internet Site Page Appendix A - Application Examples Introduction Local Area Data Set Application DDS Point-To-Point Application DDS Multipoint (Polled) Application Appendix B - Interface Signals and Connector Pinouts RJ-48 Connector DB25S Connector DB25S Connector with V.35 Interface Loopback Cable (MTS P/N 45640100) Back-To-Back Cable (MTS P/N 45050000) Appendix C - Regulatory Information FCC Regulations for Telephone Line Interconnection Canadian Limitations Notice