Table of Contents
DCA-220SSK — GENERATOR START-UP PROCEDURE (MANUAL)
13.The engine oil pressure gauge (Figure 55) will indicate the oil pressure (kg/ cm2) of the engine. Under normal operating conditions the oil pressure should be approximately 25 psi.
16.Turn the MAIN, GFCI and LOAD circuit breakers to their "ON" position (Figure 58).
Figure 58. Main and GFCI Circuit Breakers
Figure 55. Oil Pressure Gauge
14.The coolant temperature gauge (Figure 56) will indicate the coolant temperature. Under normal operating conditions the coolant temperature should be between 165 and 215 degrees Fahrenheit (Green Zone).
WATER TEMP
Figure 56. Coolant Temperature Gauge
17.Observe the generator's ammeter (Figure 59) and verify that it reads the anticipated amount of current with respect to the load. Remember the ammeter will only display a current reading if the load is in use.
40
2060
0 | 75 |
A
Figure 59. Ammeter (Load)
15.The tachometer (Figure 57) will indicate the speed of the engine when the generator is operating. Under normal operating conditions this speed should be approximately 1800 RPM’s.
18.The generator will run until manually stopped or an abnormal condition occurs.
Figure 57. Engine Tachometer
PAGE 52 —