Multiquip DCA-70SSJU Series Generator Outputs, Generator OutputVoltages, Generator Amperage

DCA-70SSJU SERIES — GENERATOR OUTPUTS

Generator OutputVoltages

A wide range of voltages are available to supply voltage for many different applications. Voltages are selected by using the voltage selector switch (Figure 15). To obtain some of the voltages as listed in Table 6 (see below) will require a fine adjustment using the voltage regulator (VR) control knob located on the control panel.

Voltage Selector Switch

The voltage selector switch (Figure 15) is located above the UVWO Hard Wire Hook-up Panel. It has been provided for ease of voltage selection.

Generator Amperage

Tables 7 and 8 describe the generator’s current output capa- bility for both 1Ø-phase and 3Ø phase applications.

Table 7. Generator Ampere

Ratings — 1Ø

kW	240V	120V
20	83	166
25	104	208
30	225	250
35	145	291
40	166	333
45	187	375
50	208	417
60 (Max)	250	500

Figure 15. Voltage Selector Switch

Voltage Selector Switch Locking Button

The voltage selector switch has a locking button to protect the generator and load from being switched while the engine is running. To lock the voltage selector switch, press and hold the red button located at the bottom of the switch.

Table 8. Generator Ampere Ratings — 3Ø

kW	208V	240V	480V
20	59	60	30
25	87	75	38
30	104	90	45
35	121	105	53
40	139	120	60
45	156	136	68
50	174	152	76
60	208	181	99

CAUTION:

NEVER change the position of the voltage selector switch while the engine is running. ALWAYS place circuit breaker in the open position before selecting voltage.

Table 6. Voltages Available

Three Phase	208 VOLT	220 VOLT	240 VOLT	416 VOLT	440 VOLT	480 VOLT
(Switchable)
Single Phase	120 VOLT	127 VOLT	139 VOLT	240 VOLT	254 VOLT	277 VOLT
(Switchable)

PAGE 32 — DCA-70SSJU SERIES — OPERATION AND PARTS MANUAL (STD) — REV. #5 (06/03/03)