CONTROLS AND INDICATORS
| 4 | 1 | 13 |
|
|
| 2 |
| |
| 5 |
|
| |
|
| 14 | 15 | |
|
|
|
| |
6 | 3 |
|
|
|
7 |
|
|
|
|
16 |
|
| EHTX |
|
8 |
|
|
| 18 |
| 9 | 11 | 17 | 19 |
|
|
|
|
12 | 10 | 10 | 12 |
Figure 2. EHTX Controls and Components (Front)
Figure 2 and Figure 3 show the location of the controls, indicators and general maintenance parts. The function of each control, indicator or maintenance part is explained below and on next page.
1.Seat – Place for operator to sit. Trowel blades will not rotate unless operator is seated. Seat is adjustable.
2.Trowel Speed Limiter Control – Used to adjust the maximum trowel speed that can be obtained when the foot pedal is fully depressed.
3.Hour Meter – Indicates number of hours machine has been used.
4.Throttle Control Lever – Controls the speed of the engine. Move the hand lever forward to increase engine speed (high), backwards to decrease engine speed (low).
5.Operator Gauges – Allows operator to monitor engine, hydraulic and electrical functions.
6.Ignition Switch – With key inserted turn clockwise to start engine.
7.Light Switch – When activated, turns on six halogen lights. Lights offer better visibility when working indoors.
8.Lights – Six low voltage halogen lights are provided with this unit.
9.Toolbox Compartment – Storage for tools.
10.Spray Nozzles – Spray nozzle for retardant.Two spray nozzles are supplied with this unit.
11.Foot Pedal – Controls blade speed. Slow blade speed is accomplished by slightly depressing the foot pedal. Maximum blade speed is accomplished by fully depressing the foot pedal.
12.Removable Steps (Left and Right) – Provides for safe footing for mounting and dismounting trowel. When removed, provides access to spider and blade assemblies.
13.Retardant Spray Control Buttons (Left and Right) – When pressed allows retardant spray to flow through the spray nozzle located at the front of the machine.
14.Hand Grip – Use to assist safe mounting and dismounting of trowel.
15.Lift Loops – Located on both the left and right sides of the main frame. Used when the trowel must be lifted onto a concrete slab.
16.Pitch Block – (Behind grill guard.) Measure and adjust pitch pressure at the pitch block.
17.Fuel Gauge/Filler Cap – Indicates the amount of fuel in the fuel tank. Remove this cap to add fuel.
18.Overflow Bottle – (Behind grill guard.) Supplies water or coolant to the radiator when radiator water or coolant level is low. Fill to indicated level as shown on bottle.
19.Hydraulic Reservoir – Part of frame. Holds hydraulic oil necessary for pump operation.
ehtx44y5
