Manuals / Multiquip / Power Tools / Cordless Sander

Multiquip EHTX44Y5 operation manual Dimensions/Specifications, Ehtx

Models: EHTX44Y5

1 50

Download 50 pages 52.7 Kb

Page 14

DIMENSIONS/SPECIFICATIONS

EHTX

C-HEIGHT B-WIDTH

A-LENGTH

Figure 1. EHTX44Y5 Dimensions

Table 1. EHTX44Y5 Specifications

	A–Length – in. (cm)	96.75 (246)

	B–Width – in. (cm)	50.0 (127)

	C–Height – in. (cm)	57.0 (145)

	Weight – lbs. (kgs.) Operating	1,946 (882.7)

	Weight – lbs. (kgs.) Shipping	(Less Pallet Material) 1926 (873.6)

	Blade Tip Speed – FPM (m/s)	1,924 (9.9)

	Rotor – RPM	0 to 160

	Path Width – in. (cm)	91 (231)

	Hydraulic Oil Capacity	7.0 gal. (26.5 liters) Less Filter Change2
	Hydraulic Oil Capacity	Add .5 gal. (1.9 liters) With Filter Change2
		Add .5 gal. (1.9 liters) With Filter Change2
		AW MV ISO68
	Hydraulic Oil1	(10W-40 Hot Weather)
		(10W-30 Cold Weather)

1.“AW” stands for anti-wear and “MV” stands for multi-viscosity. The 68 refers to the general viscosity range and is similar to 10W-30-motor oil. It is recommended that AW MV 68 hydraulic oil be used. If this type of hydraulic oil is not available then use 10W-30 engine oil (cold weather) or 10W-40 engine oil (hot weather).

2.Hydraulic Oil should be above the sight glass when cold.

page 14 — eHtx44y RIDE-ON TROWEL • operation manual — rev. #0 (01/16/13)

Image 14

Multiquip EHTX44Y5 operation manual Dimensions/Specifications, Ehtx

Contents

Model eHTX44Y5 Fuel and chemical exposure Warnings Silicosis Warning Respiratory Hazards Ehtx Ride-On Trowel Page Training checklist Completely Daily pre-operation checklist Burn hazards SaFeTy meSSageSExplosive fuel hazards Rotating parts hazards GeNeRaL SaFeTy Order Form PT-160 TROWeL SaFeTyENgINe SaFeTy Before servicing equipment „ Use well-insulated gloves when picking up the battery FueL SaFeTyBaTTeRy SaFeTy „ aLWayS shutdown engine before transporting TRaNSpORTINg SaFeTy„ NeveR lift trowel with the operator on the machine Emission Control Label ENvIRONmeNTaL SaFeTy/DeCOmmISSIONINgEmISSIONS INFORmaTION Label must remain with the engine for its entire life DIMENSIONS/SPECIFICATIONS Ehtx Guaranteed ISO 37442010 Based SpecificationsGuaranteed ISO 112012010 Based Sound Power Level in dBA b General Information Controls and Indicators Hour Meter Indicates number of hours machine has been used 25 20 Engine Components Fuel Filter Removes dirt and water from the engine fuel Seat assembly SetupTrowel Setup Instructions Battery Setup Engine Oil Level InspectionHydrauic Oil Level Fuel Place the engine speed control lever, in the LOW position Insert the ignition key into the ignition switch, FigureOperation Steering Place the engine speed control lever, in the High position Trowel Speed Limiter Control Blade Pitch Control Clean and remove any foreign debris from the trowe Engine Shut-Down MAINTENANCE OFF position Air CleanerRemove the air cleaner element Filter element from the inside out Checking Engine Oil DailyChanging Engine Oil And Filter Vol % Freezing Point Boiling Point Anti Operation in Freezing WeatherGal 9.5 liters 108 226 Fuel/Water Separator Radiator MaintenanceFuel Filter Oil And Fuel Lines Battery/Charging SystemCheck and clean battery terminals for corrosion Checking The V-Belt Left Side Trowel Speed Adjustment Right Side Trowel Speed AdjustmentChecking/Adjusting Trowel Speed Engine Tune-Up Blade Pitch Adjustment Procedure Blade Pitch Adjustment Bolt Stabilizer Ring Removal Changing Blades Place the trowel on a FLAT, Level surface Trowel Arm AdjustmentSpider Removal Remove the trowel arm from the spider plate Trowel Arm RemovalRemove spider to hydraulic motor retainingscrew Locate the trowel arm adjustment tool P/N Checking Trowel Arm Straightness Re-Assembly Trowel Arm Adjustment Fixture Components Lifting/Crush Hazard. do not lift trowel with pans attached Installing Pans Onto Finisher BladesChecking Hydraulic Steering Pressure Hydraulic Pump Pressure Test Ports Cool Oil1 155-175 PSI Hot Oil 145-165 PSI Steering Pressure AdjustmentChecking Steering Pressure Pitch Pressure Check Pitch Pressure Out of SpecificationPress the left pitch rocker switch downward Pitch Pressure Adjustment Pitch Pressure Adjustment Wiring Diagram SWITCH,KEY Hydraulic Diagram Troubleshooting Troubleshooting Ride-On Hydraulic Trowel Wiring? Troubleshooting engine Dipstick HERE’S HOW to GET Help