components (generator)
Figure 4. Generator Components (Continued)
8.Muffler/Heat Shield – Used to reduce noise and emissions. NEVER touch this heat shield when the generator/welder is in use. Always allow time for engine to cool before servicing.
9.Air Cleaner – Prevents dirt and other debris from entering the fuel system. Remove
10.Spark Plug – Provides spark to the ignition system. Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean spark plug once a week.
11.Fuel Tank Cap – Remove cap to add unleaded gasoline to the fuel tank. Replenish with clean unleaded gasoline. Make sure cap is tightened securely. DO NOT over fill.
12.Fuel Cock Lever – Turn lever downward to start (down) the flow of fuel into the carburetor.Turn upward to stop (up) the flow of fuel.
13.Choke Lever – Used for starting the engine. Close the choke lever when starting a cold engine or in cold weather conditions. The choke enriches the fuel mixture. Open the choke lever if starting a warm engine or in warm weather conditions.
14.Throttle Lever – Regulates engine speed.
15.Engine – This generator uses a 5.0 HP Honda air- cooled,
16.Engine Oil Drain Plug – Remove this plug to drain engine oil from the crankcase.
17.Recoil Starter (pull rope) –
18.FuelTank – Fuel tank capacity is 3.16 gallons (12 liters)
19.Fuel Gauge – This gauge is located on top of the fuel tank. Read this gauge to determine when fuel is low.
NOTICE
This HONDA engine is equipped with a low oil shutdown capability. A built in sensor will automatically turn off the engine should the oil level fall below a safe operating condition. Make sure the generators is placed on level ground. Placing the generators on level ground will ensure that the low oil sensor will function properly.
page 18 — gac2.2H 60 hz gENERATOR• operation and parts manual — rev. #1 (03/31/10)
