Multiquip GAC2.2H manual components generator, GFCI Ground - GFCI ground connection point

components (generator)

1 2

GAC-2.2H	120V
	15A

POWERED by

Honda Engines

211052

GR PRISE DE

TERRE

7

6 5 4

V 120

AC VOLTMETER VOLTOMETRE CA

OFF

NEUTRAL BONDED TO FRAME

NEUTRE MIS A LA MASSE A

LA CARCASSE DU MOTEUR

3

AC CIRCUIT BREAKER

INTERRUPTEUR DE

COURANT PRINCIPAL

A21210011

Figure 3. Generator Components

1.GFCI Duplex Receptacle – NEMA 5-15R, GFCI receptacle will provide 120V @ 15 amps.

2.AC-Voltmeter – Indicates (with a mark) the rated 60 Hz (single-phase) output voltage. In addition the voltmeter can also be used as a diagnostic tool. If the voltmeter indicator (needle) is below the rated voltage, engine problems may exist (low/high RPM's).

To prevent damage to the generator or power tools due to low output voltage, turn the generator OFF and consult your authorized Multiquip service dealer.

3.Main Breaker – single-pole, 15 amp circuit breaker protects the generator from short circuiting or overloading. When starting the generator always have circuit breaker placed in the OFF position.

4.Engine Oil Filler Cap – Remove cap/dipstick when the adding of engine oil is required. See Table 4 for recommended type engine oil.

5.Chassis Ground – This ground connection point should be connected to a good earth ground (ground rod).

6.Engine ON/OFF Switch – Use this switch to start and stop the engine. Place switch in ON position to start engine, to stop engine place switch in OFF position.

7.GFCI Ground – GFCI ground connection point.

gac2.2H 60 hz GENERATOR • operation and parts manual — rev. #1 (03/31/10) — page 17