Multiquip GB114BS/BP manual Components

COMPONENTS

Figure 5 shows the location of the components for the GloBug lighting system. The function of each component is described below:

1.Lamp Guard — This guard (cage) protects the lamp from being hit by objects.

2.Lamp — 1000 watt metal-halide type lamp. Replace only with MQ recommended type lamp. Always allow a suffi cient amount of time for the lamp to cool down before changing.

3.Fan Motor (Blower) — This electric motor is responsible for infl ating the balloon. It will supply a pressure of 31.26 psi /215.6 kPA. Please note that the balloon will begin to infl ate as soon as power is applied to the lighting system.

4.Balloon Cover/Carrying Case — When zipped, this protective cover acts like a carrying case.The complete lamp assembly is enclosed within the cover-carrying case. Allow a suffi cient amount of time for the lamp to cool down before covering balloon. The possibility exists of the balloon getting burned.

5.Lamp Assembly Connector — Quick-disconnect cable. Provides AC power to lamp assembly.

6.T-Handle Bolt Lock — Always tighten this lock to hold the lamp/balloon securely in place.

7.Balloon — This balloon is made of heat-resistant nylon, with a diameter of 47 inches (1200 mm).

8.Offset Pole — Supports lamp assembly when attached to the main mast. Included with the offset pole is a 17/19 mm wrench.

9.Lamp Power Cable (Output) — Connect this cable between the ballast receptacle and the lamp assembly connector.

10.Pole Clamps — Attach these clamps (2) to the main pole and external support pole. Always tighten both clamps securely to prevent slippage of the light assembly.

11.Main Pole — Used in conjunction with the offset pole to support the lamp assembly.

12.Ballast — Power source for lamp. Input power requirements are 120 VAC, 60 Hz @9.5 amps.

13.Ballast AC Power Cable (Input) — Connect this cable to a 120 VAC, 60 Hz power source.

GB114BS/BP GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #3 (01/06/09) — PAGE 15