Multiquip GB114BS/BP manual Operation, Raising the Extension Pole, Applying Power

OPERATION

RAISING THE EXTENSION POLE

1.Before raising the extension pole, make sure the T-handle bolt lock (Figure 6-O) is securely tightened. This will prevent the balloon/lamp assembly from falling off. In addition make sure that the lamp power cable is connected to the mating end of the power source cable.

2.Raise extension pole (Figure 6-L) to desired height. Watch out for any overhead obstructions.

3.Using 19 mm wrench, tighten extension clamp bolt (Figure 6-Q) securely. Keep wrench in a safe place where it will not get lost.

DANGER

ALWAYS make sure the area above the lighting system is open and clear of overhead power lines and other obstructions. Contact with overhead power lines or other obstructions could result in equipment damage, Serious

Injury or Death!

DANGER

When raising the extension pole, ALWAYS be on the lookout for overhead obstructions such as high voltage power lines. The possibility exists of electrocution, even death! if the lighting system comes in contact with high voltage power lines.

APPLYING POWER

1.Make sure the power ON/OFF switch (Figure 10) located near the bottom of the ballast is in the OFF position.

ON/OFF	BALLAST
SWITCH

OFF

Figure 10. Power OFF/ON Switch (Off Positon)

2.If using a power source (Figure 11) other than a portable generator, plug the AC power cord from the ballast into a 120 VAC, 60 Hz receptacle that is protected by a at least a 15 amp circuit breaker.

CONNECT
TO BALLOON	BALLAST
POWER
CABLE

EXTERNAL

SINGLE-PHASE

(120 VAC)

POWER SOURCE

AC POWER

CORD

RECEPTACLE

Figure 11. Applying 120 VAC Power

NOTICE

If using a portable generator, start the generator as referenced in the "Start-up Section" of the supplied generator manual.

Once the generator has started, plug the AC power cord from the ballast (Figure 11) into a GFCI receptacle on the generator.

PAGE 18 — GB114BS/BP GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #3 (01/06/09)