MAINTENANCE
CAUTION
Before performing any maintenance procedures, be sure to READ the lamp, balloon, and general safety guidelines in this manual. Failure to read and understand these safety guidelines could cause severe equipment damage and bodily harm.
REMOVING THE LAMP ASSEMBLY
1. Allow lamp (Figure 17) |
CAUTION
DO NOT use excessive force when zipping or unzipping the balloon. The possibility exists of the zipper tearing, which would make the balloon unusable.
REMOVING THE BALLOON
1.Expose the balloon (Figure 19) by pulling down on the velcro tabs and unzip the protective cover as shown in Figure 7. Next, fold the protective cover into itself and zip
changing. |
ZIPPERBALLOON (BOTTOM)
ZIPPER
(TOP)
DO NOT USE EXCESSIVE FORCE WHEN ZIPPING OR
UN ZIPPING THE 
BALLOON
PROTECTIVE
COVER
(FOLDED)
Figure 17. Hot Lamp Surface
2.If lamp assembly is attached to offset pole, loosen T-handle knob (Figure 18) that secures the lamp to the offset pole.
LAMP
ASSEMBLY
KNOB
Figure 18. T-Handle Knob
3.Lift lamp assebly from offset pole, and place on a suitable work bench that is free of dirt, and sharp objects that could damage the balloon.
Figure 19. Exposing the Balloon
2.Unzip the zipper (Figure 19) at the bottom of the balloon and roll the balloon envelope upwards to expose the lamp (Figure 20). Remove the lamp guard to gain access to the lamp. DO NOT use excessive force when unzipping the balloon.
LAMP GUARD | BALLOON |
|
PIPE FRAME
TO REMOVE
LAMP GUARD
LIFT UPWARDS
FROM PIPE FRAME
Figure 20. Removing the Lamp Guard
GB114BS/BP GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #3 (01/06/09) — PAGE 21
