OPERATION
REMOVING BALLOON PROTECTIVE COVER
CAUTION
DO NOT use excessive force when zipping or unzipping the balloon. The possibility exists of the zipper tearing, which would make the balloon unusable.
1.Expose the balloon by unsnapping the buttons and unzipping the protective cover as shown in Figure 11.
| UNZIP | BALLOON | |
SNAPS | PROTECTIVE | ||
FULLY | |||
COVER | |||
| |||
| EXPOSED | ||
|
|
FOLD PROTECTIVE
COVER INTO ITSELF
Figure 11. Removing Protective Cover
2.Next, fold the protective cover into itself and zip. See Figure 11.
INFLATING BALLOON AND TURNING ON LAMPS (LT12 ONLY)
1.On LT12 series light towers, reconnect negative battery cable (black).
2.Slightly raise the light tower mast to allow clearance for the balloon to inflate.
3.Start the light tower engine as referenced in the LT12 light tower operation manual.
4.Once, the engine has started, place the main circuit breaker switch (Figure 12) on the LT12 control panel in the ON position.
LT12
LIGHT TOWER
240 VAC/30A |
| 120 VAC/15A |
MAIN |
| GFCI |
BREAKER |
| BREAKER |
MAIN |
CIRCUIT |
BREAKER |
ON |
CB1 CB2 CB3 CB4
LIGHT CONTROL/BREAKER
Figure 12. Main Breaker ON (LT12)
5.Next, turn on lamp circuit breakers.The balloon should begin to inflate and the lamps will light.
6.Secure any unused lamp cables.
7.Raise the light tower mast to the desired upright height.
PAGE 24
