![](/images/new-backgrounds/1272048/27204851x1.webp)
MAINTENANCE
REPLACING LAMP
DANGER
Never attempt to replace lamp in a wet place. The possibility exists of electric shock.
WARNING
Always allow sufficient time for the lamp to cool down before replacing.The possibility exists of severe burns if hot lamp is touched.
\
CAUTION
Always shutdown power source and remove balloon assembly from mast when replacing a broken lamp. Utmost care should be taken in handling broken lamp. The possibility exists of serious injury from handling a broken lamp.
1.Unzip the zipper at the bottom of the balloon and roll the balloon up to expose the lamp. See Figure 15.
BALLOON
ZIPPER
Figure 15. Exposing Balloon
2.Release the lamp guard hooks from the poles and remove the two lamp guards. See Figure 16.
LAMP
GUARD
LOCK HOOK
Figure 16. Removing Lamp Guard
3.Press the tabs on the lamp holder and push up lamp holder to release it from lamp. Do the same to the lower lamp if necessary. See Figure 17.
LAMP HOLDER
Figure 17. Lamp Holder
4.Remove lamp from the lamp socket by turning lamp counterclockwise. See Figure 18.
LAMP
LAMP
SOCKET
Figure 18. Removing Lamp
5.Install new lamp into socket and turn lamp in a clockwise direction until tight. See Figure 19.
LAMP
LAMP
SOCKET
Figure 19. Installing New Lamp
PAGE 26