Safety Information
LIgHT TOWeR saFeTY
DangeR
neveR operate the equipment in an explosive atmosphere or near combustible materials.An explosion or fi re could result causing severe bodily harm or even death.
WaRnIng
neveR disconnect any emergency or safety devices. These devices are intended for operator safety. Disconnection of these devices can cause severe injury, bodily harm or even death. Disconnection of any of these devices will void all warranties.
CauTIOn
neveR lubricate components or attempt service on a running machine.
aLWaYs ensure light tower is on level ground before use so that it cannot slide or shift around, endangering workers. Always keep immediate area free of bystanders.
ALWAYS make sure trailer is leveled with all outriggers extended before raising tower. Outriggers must remain extended while tower is up.
ALWAYS keep area behind trailer clear of people while raising and lowering mast.
neveR remove safety pin or pull mast locking pin while tower is in a raised position!
CHeCK the mast and winch cables for wear. If any problem occurs when lowering or raising the tower, STOP immediately! Contact a trained technician for assistance.
neveR pivot or retract mast while unit is operating.
neveR use the light tower mast as a crane. DO nOT lift anything with the mast.
neveR attach anything to the light tower mast unless it is an authorized Multiquip component.
aLWaYs lower the light tower when not in use, or if high winds or electrical storms are expected.
NOTICE
aLWaYs keep the immediate area surrounding the light tower clean, neat, and free of debris.
aLWaYs keep the machine in proper running condition.
Fix damage to machine and replace any broken parts immediately.
aLWaYs store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children and unauthorized personnel.
To prevent the light tower from overturning, neveR use in winds that exceed 65 mph (105 kph).
LaMp saFeTY
WaRnIng
neveR attempt to replace lamp with the power on. Always shut down the engine and turn off circuit breakers when changing the lamp.
aLWaYs allow a sufficient amount of time for the lamp to cool before touching or changing. The possibility exists of severe burns.
CauTIOn
neveR use force when installing the lamp.Excessive force could cause the lamp to break, causing bodily harm.
NOTICE
neveR leave any grease or oil residue on lamp surface when replacing or removing lamp. This can create hot spots, reducing the service life of the lamp.
aLWaYs make sure lamp surface is clean and dry.
aLWaYs replace with MQ recommended type lamp.
aLWaYs have a trained technician install and remove a fl oodlight, or replace any damaged fi xture wiring.
MLT25 SERIES LIGHT TOWER • operation manual — rev. #0 (11/28/12) — page 7
